TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download

Page 910 of 1563

TM 9-2815-220-24 FUEL INJECTION TUBES REPLACEMENT 0113 00 INSTALLATION (Continued) 2. Install four fairlead halves (19) between tube assemblies and four double-angle brackets (20, 21, 22, and 23) with cut-off corners adjacent to manifolds (see detail A). CAUTION When bending injection tubes is required, be careful not to nick tubing. The bending tools are designed to allow bending without nicks. 3. Assure that fairlead halves (19) are aligned with bracket (20, 21, 22, and 23) holes and align tubes to fit within 1/8 inch (3.175 mm) in any direction with fairlead halves. Use two bending tools (24) (item 13, WP 0177). 4. Install four fairlead halves (19) on top of fuel injection tubes (see detail A). a. Apply a small amount of Lubriplate (item 23, WP 0173) to threads of 16 screws (25). b. Install retainers (26), using screws (25) and new self-locking nuts (27) (item 38, WP 0175), onto four double-angle brackets (20, 21, 22, and 23). c. Tighten 16 screws (25) to 160-180 inch-pounds (18-20 Nm). 2 2 20 23 2 1 A A A 2 24 4 1 2 2 27 6 5 9 A WP 0113 00-6