TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download
Page 823 of 1563
TM 9-2815-220-24 FLYWHEEL AND SPUR GEAR REPLACEMENT (2CA, 2DA) 0102 00 REMOVAL (Continued) WARNING Flywheel is heavy. Be sure that lifting device is attached and do not allow flywheel to swing about uncontrolled. Failure to comply may result in personal injury. 4. Pull flywheel (2). a. Install three of the removed mounting screws (4) into puller holes provided in flywheel (2). CAUTION Use care in removing flywheel from dowel pins so as not to cause binding. Damage may occur to dowel pin or flywheel hole. b. Alternately tighten three screws (4) to pull flywheel (2) just enough to install eyebolt (6) (item 65, WP 0176). 8 2 4 6 7 c. Attach a suitable lifting device (7) to eyebolt (6) and take out slack. d. Continue to alternately tighten screws (4) until flywheel (2) is free from dowel pins (8) in crankshaft. e. Place flywheel on wooden pallet or other suitable safe location, then remove three screws (4) and eyebolt (6). WP 0102 00-3