TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download
Page 613 of 1563
TM 9-2815-220-24 CYLINDER OIL DRAIN TUBES REPLACEMENT 0077 00 INSTALLATION 1. Assemble left bank oil drain tube assembly (43). a. Lubricate inside of new hoses (47) (item 313, WP 0175) with lubricating oil (item 21, WP 0173). b. Place clamp (46) on inboard end of tube (48) and position towards fluid passage bolt hole to allow installation of hose (47). c. Install hose (47) on inboard end of tube (48) and position it about half way onto tube. d. Place clamp (46) on inter-cylinder tube (49) and position it towards fluid passage bolt hole. e. Insert tube (49) approximately half way into opposite end of hose (47). f. Repeat procedure for remaining inter-cylinder tubes (49) and end tube (50), leaving clamps (46) loose. 2. Install left bank oil drain tube assembly (43) onto engine. a. Position a new lubricated gasket (45) (item 283, WP 0175) top and bottom of each tube (48, 49, 50) and secure at each cylinder with a fluid passage bolt (44). b. Center hoses (47) at each location and secure with clamps (46). c. Torque-tighten fluid passage bolts to 275-300 inch pounds (31-34 N•m). DAMPER END FLYWHEEL END 48 LEFT BANK OIL DRAIN 47 46 44 45 49 50 43 WP 0077 00-7