TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download
Page 38 of 1563
TM 9-2815-220-24 GENERAL INFORMATION (Continued) 0001 00 SAFETY, CARE, AND HANDLING Read all WARNINGS in the front of this manual, and observe all WARNINGS found throughout this technical manual. Some of the maintenance and repair procedures require the use of lubricants, solvents, and cleaning fluids that may be dangerous or harmful if safety precautions are not observed. Read manufacturer’s warnings and cautions on product labels before using, and observe recommended safety precautions. Avoid damage to engine subassemblies and parts during disassembly, cleaning, inspection, repair, and assembly procedures. Nicks, scratches, and dents caused by careless handling can cause oil leakage or improper functionality leading to premature subassembly or part failure. Care must be used to protect the engine against contamination. This is especially true during overhaul or maintenance operations when the engine is partially disassembled. Dirt, small tools, and parts could fall into access holes and cavities. This could result in an engine failure. When an engine is not being serviced, protect it from contamination. CALIBRATION Refer to the appropriate equipment manual for your equipment for calibration information. COMMON TOOLS AND EQUIPMENT For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment (MTOE), CTA 60-970; or CTA 8-100, as applicable to your unit. The general mechanic's tool kit is identified in the individual maintenance paragraphs by nomenclature, item number and work package. No tool in the kit is further identified. Other tools required for performance of tasks for the maintenance levels covered in the manual are identified in “SETUP” and are referenced to the Tool Identification List, WP 0176. “Other Tools” includes tools which are part of the shop sets authorized to section/teams; tools authorized by RPSTL and CTA 50-970; special tools and equipment, fabricated tools; and items of TMDE. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT Work Package 0176, Tool Identification List, includes information on special tools and equipment. See TM 9-2815-220-24P for lists and illustrations of special tools needed to maintain the engine. See WP 0177 in this manual for an illustrated list of manufactured items needed to maintain the engine. REPAIR PARTS See WP 0175 in this manual for a list of mandatory replacement parts needed to maintain the engine. END OF WORK PACKAGE WP 0001 00-4