TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download
Page 379 of 1563
TM 9-2815-220-24 WIRING HARNESS AND CABLE REPAIR 0056 00 REPLACEMENT OF CONNECTORS (Continued) Disassembly of Typical Male-Type Plug with Ridged Locking Nut 1. Heat boot (A) on shell assembly (B) and roll back on cable (C). 2. Unscrew nut (D) from shell assembly (B) and slide back on cable (C). 3. Drive pin contacts (E) out through rear of shell (F) with pin extractors. 4. Using soldering gun (item 108, WP 0176), unsolder or cut cable (C) leads from pin contacts (E). Assembly of Typical Male-Type Plug with Ridged Locking Nut 1. Strip cable (C) insulation equal to depth of wells in pin contacts (E). 2. Insert cable (C) leads into wells of pin contacts (E) and solder (using item 38, WP 0173) or crimp. 3. Push pin contacts (E) into shell (F) from rear until seated. 4. Screw nut (D) onto shell assembly (B). 5. Apply a thin even layer of adhesive (item 1, WP 0173) to shell assembly (B) and roll boot (A) onto shell assembly (B). F D E A B E C WP 0056 00-19