TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download

Page 372 of 1563

TM 9-2815-220-24 WIRING HARNESS AND CABLE REPAIR 0056 00 REPLACEMENT OF CONNECTORS The remainder of this work package contains procedures for replacement of cable connectors, male and female plugs and receptacles. Disassemble/assemble the connectors as shown in the illustration that most closely matches your application. NOTE Before proceeding, see detailed instructions on soldering and solder (TB SIG 222). When removing more than one wire from a multiple wire receptacle, record which wire was removed from which pinhole. Cable identifiers are attached to cables. These tags are embossed with the cable identification number. Cable identifier numbers are shown on the systems wiring diagram. Wire identifiers are embossed with the individual wire number. Wire identifier numbers are also shown on systems wiring diagram. If cable or wires are replaced, remove tags from old wire and place them on new wire. All pins (male connectors) and sockets (female connectors) are alphabetically coded. Coded identification starts at connector key or groove. Pin (male connector) identifying letters run clockwise. Socket (female connector) identifying letters run counterclockwise. Do continuity checks upon completion of cable or harness repair. Rubber-to-rubber contacts of bell-type connectors may be lubricated lightly with silicone compound MIL-S-8660 (item 34, WP 0173) to assist assembly. WP 0056 00-12