TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download
Page 318 of 1563
TM 9-2815-220-24 STARTER MOTOR REPLACEMENT 0049 00 INSTALLATION (Continued) CAUTION It is of utmost importance that the starter support, cradle, and U-bolt be installed in a manner that will not disturb starter alignment and still furnish adequate support to minimize vibration. Perform step 2 in the sequence as written. Misalignment of 0.010-inch in any direction is sufficient to cause a leak (pressure loss) between the starter mounting flange and the starter housing. 2. Install starter support bracket (10). a. Position starter support bracket (10) and cradle (27) as an assembly on oil pan and secure using three screws (8) with flat washers (9). b. Tighten only until screw (8) heads engage washers (9) (finger tight). c. Loosen four screws (33) allowing free movement between cradle (27) and support (10). d. Position U-bolt (26) over starter (23) and secure to cradle (27) with two clamping bars (25) and new self-locking nuts (24) (item 282, WP 0175) assuring that cradle (27) sits flat on support (10). Tighten nuts (24) evenly. e. Tighten four screws (33) securing cradle (27) to support (10). f. Tighten three screws (8) securing starter support (10) to oil pan. Fourth screw will be installed with ground straps. 33 26 8 24 25 9 27 10 23 WP 0049 00-6