TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download

Page 30 of 1563

TM 9-2815-220-24 HOW TO USE THIS MANUAL HOW TO USE WORK PACKAGES (Continued) Referring to another Work Package Steps within a work package may refer to another work package in this manual: “Remove fuel injection pump assembly (WP 0115).” In this example, only the REMOVAL part of the referenced work package is to be performed. Cleaning and Inspection General cleaning and inspection procedures for every work package are found in WP 0028, General Maintenance Instructions. Use these procedures to clean and inspect any part being removed, repaired, or installed. Special cleaning and inspection, if required, will be covered in the procedural work package. Check This term is used when an instruction step requires the use of a tool to determine a specific value. When checking the fit of a part, a range of acceptable values may be provided. The letter L or T may follow a value. L means looseness of fit, T means tightness of fit. Go to End of Work Package This term is used in a work package step that contains a conditional situation that might require performance of more steps. If no more steps are to be performed, the work package or work package element is complete, and you are directed to GO TO END OF WORK PACKAGE. Anytime you arrive at END OF WORK PACKAGE, you must return to the maintenance work package or troubleshooting work package that sent you to that work package. All Work Packages The following comments apply: 1. Items that are always consumed will be listed under Mandatory Replacement Parts or Expendable Materials in the INITIAL SETUP section of the work package and will be referred to as “new” when installed. Examples of items usually consumed are: Bearings Gaskets Lock wire Self-locking nuts Filters Preformed packings Hoses O-rings Lock washers 2. Items that are to be replaced or discarded as the result of a condition (as determined when performing steps that check and inspect) will not be listed under Mandatory Replacement Parts or Expendable Materials. They will not be referred to as “new” when installed. xii