TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download
Page 28 of 1563
TM 9-2815-220-24 HOW TO USE THIS MANUAL HOW TO USE WORK PACKAGES The following is an example of the "INITIAL SETUP" section in a maintenance work package. Not every work package will have all of the categories listed; only those that apply will be there. TM 9-2520-220-24 INTAKE AND EXHAUST VALVE CLEARANCE ADJUSTMENT 0034 00 THIS WORK PACKAGE COVERS: Before Adjustment, Adjustment, and After Adjustment INITIAL SETUP: Tools: General mechanic’s tool kit (item 121, WP 0176) Torque wrench, 0-300 inch-pounds (item 124, WP 0176) Manufactured Items: Engine (flywheel) turning tool, 2DR only (item 4, WP 0177) Mandatory Replacement Parts: Gasket (2) (item 350, WP 0175) Expendable Materials: Lubriplate (item 23, WP 0173) Personnel Required: Track Vehicle Repairer (2) 63H10 Equipment Conditions: Cooling fans, vane housings, and fan housing removed (WP 0054) LEGEND TITLE: Identifies the name and number of the work package. THIS WORK PACKAGE COVERS Describes the overall actions to be performed (remove, disassemble, adjust, assemble, install, etc.). Tools: This is a list of the tools and equipment you will need. Part number and national stock number of each tool can be found in the referenced work package. Tools found in the general mechanic’s tool kit are not listed separately. Expendable Materials: These supplies are needed to perform the work package. Manufactured Items: These are items that have to be manufactured or fabricated in order to do the work package. The referenced work package describes how to do this. Mandatory Replacement Parts: The parts listed are those you must replace every time the work package is performed. Use the Repair Parts and Special Tools List (RPSTL) TM 9-2815-220-24P to order the parts you need for the work package. Personnel Required: This tells you the person authorized to perform the work package. Equipment Conditions: Describes the condition the equipment must be in before you start the work package. Each condition is followed by a work package reference. Use this reference to find the work package that sets up that equipment condition. NOTE: When you go to the referenced work package, you mush also perform the Equipment Conditions on that referenced work package. x