TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download

Page 196 of 1563

TM 9-2815-220-24 STANDARD MAINTENANCE INSTRUCTIONS 0028 00 REPAIR (Continued) Gears and Shafts 1. Replace all cracked gears and shafts, and shafts that are bent or twisted. 2. Replace all gears and shafts that do not conform to tolerances specified in the repair standards tables in the inspection section of the procedural work package. 3. Replace all gears and shafts having worn, galled, nicked, burred, or pitted teeth and splines. 4. Remove any sharp fins and burrs from splines with crocus cloth (item 9, WP 0173) dipped in cleaning compound (item 8, WP 0173) or with a soft honing stone. 5. Replace all splined gears and shafts that are damaged to the point of impairing assembly or operation. 6. Replace all gears and shafts having splines that do not match properly with mating splines. Inserts For standard helical coil insert procedures see Work Package 0029. For standard threaded insert procedures see Work Package 0030. Oil Seals Replace all oil seals at engine repair. During field repair, replace oil seal when thin feather edge is damaged or when seal material is hard or brittle. 1. Press damaged oil seal from casting or adapter. Be careful not to damage bore. WARNING Cleaning Compound Solvent 2. When oil seal bore in casting or adapter is burred or damaged to the point where an oil-tight seal is impossible, repair or replace casting or adapter. Remove slight nicks, burrs, and scratches with crocus cloth (item 9, WP 0173) dipped in cleaning solvent (item 8, WP 0173). 3. Install new oil seal in casting bore or adapter using suitable oil seal replacement tool. Oil Transfer Tubes 1. Remove oil transfer tubes that are loose or damaged. 2. Install new oil transfer tube using sealing compound (item 31, WP 0173). WP 0028 00-16