TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download

Page 184 of 1563

TM 9-2815-220-24 STANDARD MAINTENANCE INSTRUCTIONS 0028 00 CLEANING (Continued) Inspect all air and fluid openings, lines, and hoses. Make sure they are capped. WARNING Cleaning Compound Solvent 1. Clean all parts before inspections, checks, after repair, and before assembly. Use cleaning solvent (item 8, WP 0173) or approved cleaner. Remove gum, varnish, and sealant compound by soaking parts in cleaning solvent and scrubbing with a soft bristle brush. Clean thoroughly to remove any dirt and residue. Dry parts with wiping rag (item 26, WP 0173). 2. Keep hands free of grease; grease collects dirt. 3. Except where specified, never use abrasives, files, scrapers, wire brushes, or sharp tools on surfaces where the finish is important to the operation or sealing of parts. 4. Apply a thin film of clean oil to parts that have been cleaned and dried to prevent rusting. 5. Never use lye or caustic solutions that will corrode or etch metal surfaces. 6. After cleaning, cover and wrap parts to protect from dirt. Bearings Bearings require special attention for cleaning and oiling. NOTE Do not immerse sealed-type ball bearings in cleaning solvent or hot oil. Entrance of cleaning agent will destroy lubricants sealed in bearing at time of manufacture. Loss of lubricant will result in premature failure of bearing and possible damage to the engine. 1. Remove the surface dirt, oil or grease from the bearings. CAUTION Do not use compressed air for cleaning or drying ball or needle bearings. Damage to bearings will result from spinning of bearing by air blast. 2. For sealed-type ball bearings, clean by wiping the exterior surfaces with a clean cloth (item 10, WP 0173) moistened in cleaning solvent (item 8, WP 0173). 3. For other bearings, place in hot oil (about 150 °F) to loosen congealed oil and grease. 4. After cleaning, wrap the bearings tightly in oiled or waxed paper until inspection and assembly. 5. Refer to TM 9-214, Inspection, Care, and Maintenance of Antifriction Bearings, for information on inspection, care, and maintenance of bearings. WP 0028 00-4