TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download
Page 1479 of 1563
TM 9-2815-220-24 TORQUE LIMIT TABLES 0174 00 WP 0174 00-3 TABLE 1: SPECIAL TORQUE LIMITS (Continued) DESCRIPTION Torque: inch-pounds Compression sleeve fitting tube nuts: (Lubrication Note number 4 applies) Tube o.d. Material 1/8 Plastic w/support (2 F.F.F.T.) 1/4 Plastic w/support (2 F.F.F.T.) 3/8 Steel (1-1/4 F.F.F.T.) 1/2 Steel (1 F.F.F.T.) 75-110 135-150 215-280 470-550 Connecting rod bolt nuts: alternately tighten 100-150, then 600-650 and then the listed torque 1250-1300 Constant torque clamps Tighten until spring bottoms, then back-off 1 to 1-1/2 turns Crankcase through-bolts 640 Crankcase-main bearing stud nuts: 1. First tighten all nuts to 500 inch-pounds 2. Then tighten all nuts to listed torque 3. Check stud stretch: Optimal: .019 - .022 inch 4. Tighten nuts as applicable to obtain proper stretch. 5. Do not exceed .024-inch stretch when aligning wire holes. NOTE Studs which exceed the stretch limits at less than 700 inch-pounds must be replaced. Studs which exceed the stretch limits above 700 inch-pounds must be loosened and re-subjected to steps 1-5. Re-torquing any singular stud nut is not allowable. The adjacent stud nut must also be loosened and re-torqued in sequence. 700-825 Cylinder deck studs (1/2-inch), Installation of 450-1000 Cylinder flange base nuts, Installation of 840-860 Cylinder head oil drain tube to cylinder head (1/2-20 bolts) 275-300 Damper housing oil drain valve 135-150 Damper housing to crankcase (3/8-24 nuts) 225-250 Damper to crankshaft 975-1025 Exhaust manifold support bracket bolt/nut 400-425 Fan adapter to fan cap screws 150-175 Fan adapter to fan drive shaft unit 600-625 Fan clutch slip torque 300-350