TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download

Page 1404 of 1563

TM 9-2815-220-24 FUEL INJECTION ADVANCE CONTROL TEST 0162 00 TEST 1. Turn motor switch (7) “ON”. 2. Push jog/run switch (6) and turn speed regulator control (8) clockwise to obtain a speed of 300 rpm as indicated on tachometer (26). 3. Observe oil pressure indicator gauge (27) and fuel pressure indicator gauge (28). CAUTION Turn master switch handle “OFF” if there is no indication of oil or fuel pressure on the gauges. Investigate and correct the deficiency before continuing test. Failure to comply may result in damage to equipment. a. Both gauges should register more than zero (0); however, maximum pressures will not be evident until a speed of 2000 rpm is obtained. 4. Operate test stand at 300 rpm until the oil temperature dial (29) stabilizes at 200 °F (93.33 °C). a. It may require several minutes of running at 300 rpm to warm the entire system to operating temperature. 28 26 2 27 9 8 6 7 WP 0162 00-8