TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download
Page 1387 of 1563
TM 9-2815-220-24 FUEL INJECTION ADVANCE CONTROL REPAIR 0161 00 INSPECTION (Continued) 16. Measure vane (24). a. Measure width (A), inside diameter (B), and width of slots (C) in vane (24). b. Replace advance unit if vane (24) is not within specifications in the following table. 17. Measure cover (7). a. Measure inside diameter (D) and outside diameter (E) of cover (7). b. Replace advance unit if cover (7) is not within specifications in the following table. Location Sizes and Fit of New Parts inches (mm) Wear Limits A (Vane width) Check concurrently with vane housing to provide 0.0010-0.0015 (0.0254-0.0381) end clearance. None B (Vane) 1.8730 (47.5742) 1.8735 (47.5869) 1.8740 (47.5996) C (Vane slots) 0.1020 (2.5908) 0.1060 (2.6924) 0.1070 (2.7178) D (Cover) 1.8125 (46.0375) 1.8130 (46.0502) 1.8135 (46.0629) E (Cover) 2.3735 (60.2869) 2.3745 (60.3123) 2.3730 (60.2742) 7 D B A C E 24 7 WP 0161 00-11