TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download
Page 1385 of 1563
TM 9-2815-220-24 FUEL INJECTION ADVANCE CONTROL REPAIR 0161 00 INSPECTION (Continued) 4. Measure outside diameter (A) of both threaded pins (11). Replace threaded pins if not within specifications in the following table. 5. Measure inside diameter (B) of hole in two flyweights (16). Replace flyweights if not within specifications in the following table. 6. Measure outside diameter (C) of pin on two flyweights (16). Replace flyweight assemblies if not within specifications in the following table. 7. Measure outside diameter (D) of fluid regulating valve (14). Replace fluid regulating valve if not within specifications in the following table. 8. Measure inside diameter (E) of fluid regulating valve (14). Replace fluid regulating valve if not within specifications in the following table. 9. Measure width of slots (F) in fluid regulating valve (14). Replace fluid regulating valve if not within specifications in the following table. Location Sizes and Fit of New Parts inches (mm) Wear Limits A (Threaded pins) 0.3110 (7.8994) 0.3115 (7.9121) None B (Flyweight holes) 0.3120 (7.9248) 0.3130 (7.9502) None C (Flyweight pins) 0.2500 (6.3500) 0.2510 (6.3754) 0.2490 (6.3246) D (Regulating valve) 1.8710 (47.5234) 1.8715 (47.5361) 1.8708 (47.5183) E (Regulating valve) 1.5015 (38.1381) 1.5020 (38.1508) 1.5030 (38.1762) F (Regulating valve slots) 0.2510 (6.3754) 0.2550 (6.4770) 0.2560 (6.5024) 16 14 F 11 D E A B C WP 0161 00-9