TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download
Page 1220 of 1563
TM 9-2815-220-24 CONNECTING ROD ASSEMBLY REPAIR 0143 00 REPAIR 1. Replace worn or damaged connecting rod sleeve-bearing (7). a. Remove old sleeve bearing (7) using fixture (11) with sleeve (12) and guide (13). WARNING Wear gloves when handling hot or cold parts. Failure to comply may result in personal injury. b. Heat connecting rod (1) to 250 °F (121.1 °C) for approximately 20 minutes. c. Chill sleeve-bearing (7) to 35 °F (-1.6 °C). d. Place connecting rod (1) on fixture (11) (item 5, WP 0177). e. Install sleeve-bearing (7) using fixture (11) and guide (14). f. Burnish to seat bearing (12), then finish ream to 2.1275 to 2.1277 inches (54.0385 to 54.04358 mm). Check that bore centers are maintained as in step 6 of Inspection. 11 7 12 13 6 14 Mandrel Assembly WP 0143 00-10