TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download
Page 1184 of 1563
TM 9-2815-220-24 CRANKSHAFT REPLACE/REPAIR 0139 00 INSTALLATION (Continued) 10. Tighten main bearing cap (6) nuts (8). a. Make sure that nuts are loose (6), then measure and record the height of four main bearing cap studs (28) at number 4 location. Use a flat surface plate (30) and dial indicator (27). 30 28 8 6 27 b. At number 4 main cap (6), in a crosshatch pattern, torque-tighten four slotted nuts (8) to 42 foot-pounds (57 N•m). Using the same crosshatch pattern, torque-tighten the same four nuts (8) to 58 foot-pounds (79 N•m). c. Using a flat surface plate (30) and dial indicator (27) (item 65, WP 0176), measure and record the height of four main bearing cap studs (28) at number 4 location. Subtract the first reading from the second, this is the stud stretch. d. Tighten nuts (8) to align with safety wire hole in stud and attain a stretch of 0.019 to 0.024 inch (0.4826 to 0.6096 mm). e. Any stud that exceeds the maximum stretch (0.024 inch, or 0.6096 mm) prior to the nut obtaining minimum torque (58 foot-pounds, or 79 N•m) must be replaced. f. Any stud that its nut reaches maximum torque (69 foot-pounds, 94 N•m) prior to obtaining minimum stretch (0.019 inch, or 0.4826 mm) may be loosened and tried again. Loosening of a single nut is not allowed; all nuts on that bearing cap must be loosened. If the condition exists after the second try, the stud must be replaced. g. Repeat for remaining caps in the following order 3,5,2,6,1, and 7. h. Secure 28 slotted nuts (8) with new lock wire (7) (item 44, WP 0173). 11. Install accessory drive gear and oil seal housing (see Work Package 0158). WP 0139 00-22