TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download
Page 1109 of 1563
TM 9-2815-220-24 CYLINDER ASSEMBLY REPLACEMENT 0133 00 INSTALLATION (Continued) 1. Rotate maintenance stand so cylinder assembly (1) is vertical. 2. Install new O-ring (12) on cylinder (1) base. a. Apply light coat of lubricating oil (item 21, WP 0173) to new O-ring (12) (item 79, WP 0175). b. Position O-ring (12) on cylinder (1) base making sure that it is not twisted or otherwise improperly seated. NOTE Assembly of piston rings to piston is covered in WP 0142, Pistons, Rings, and Associated Parts Replace/Repair. 3. Install piston (6) into cylinder assembly (1). a. Coat sides of piston (6) with lubricating oil (item 21, WP 0173). b. Stagger the four piston ring gaps 90 degrees apart from each other and ensure ring gaps do not line up with piston pin (10) (see illustration below). c. Install piston (6) and rings in cylinder assembly (1) using piston ring compressor (13) (item 21, WP 0176). The piston position number must always correspond to the cylinder number marked on intake valve side of valve rocker flange. The arrow on the piston boss must be directed toward the exhaust port outlet. d. Guide piston (6) and rings into cylinder assembly (1) until all piston rings have entered the cylinder bore. e. Slide the piston ring compressor (13) from piston (6). WP 0133 00-9 6 X marks ring gap locations 12 1 13 6 10