TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download
Page 1024 of 1563
TM 9-2815-220-24 THROTTLE/GOVERNOR (ADJUSTABLE) CONTROL ROD REPAIR 0125 00 INSPECTION (Continued) 2. Measure the clearance (A) between ball and socket (endplay) of two rod end/bearings (1, 2) at ends of governor control rod (3) using a dial indicator (item 65, WP 0176). Replace rod end/bearing if not within the following limits. Location Sizes and Fits of New Parts inches (mm) Wear Limits A (Bearing endplay) 0.0005 (0.0127) 0.0015 (0.0381) 0.0020 (0.0508) 2 3 1 A REPAIR NOTE Either rod end/bearing (1 or 2) can be repaired in the same manner, only one end is described. One end is right-hand thread, and the opposite end is left-hand thread. 1. Remove rod end/bearing (1 or 2) from control rod (3) by loosening nut (4 or 5) and then turning rod end/bearing. 2. Install new rod end/bearing (1 or 2), then set length to approximately 10.92 inches (277.3680 mm) and tighten nut (4, 5). 3 4 1 5 2 END OF WORK PACKAGE WP 0125 00-2