TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download
Page 1011 of 1563
TM 9-2815-220-24 THROTTLE CONTROL SOLENOID ASSEMBLY AND ASSOCIATED PARTS REPLACE/REPAIR (2DR) 0123 00 ADJUSTMENT 1. With the throttle linkage in full throttle position (A), clearance between stop pin of remote control lever (8) and pump drive adapter assembly (14) must be 1/8 inch (3.175 mm) nominal. 2. With the throttle linkage in idle position (B), clearance between stop pin of remote control lever (8) and pump drive adapter assembly (14) must be 3/16 inch (4.7625 mm) minimum. 3. When the foregoing clearances are not met, loosen lock nuts (77, right-hand thread) and (78, left-hand thread) on control rod assembly (4), and adjust as necessary to obtain required clearance. 4. Tighten lock nuts (77 and 78) after adjustment. 77 78 4 Pin Full Throttle Idle Position Stop Pin Stop Pin Idle Position Full Throttle Solenoid Speed Control 28 28 56 56 B A Idle Position Full Throttle Pin 14 14 8 8 Remote Control Lever Idle Adjustment NOTE Engine idle adjustment and solenoid speed control adjustments are made with the engine running. Engine idle is controlled with the idle adjustment screw (28), and solenoid speed control is adjusted with solenoid speed adjustment screw (56). See Work Package 0043. END OF WORK PACKAGE WP 0123 00-17 (18 blank)