TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download
Page 1005 of 1563
TM 9-2815-220-24 THROTTLE CONTROL SOLENOID ASSEMBLY AND ASSOCIATED PARTS REPLACE/REPAIR (2DR) 0123 00 ASSEMBLY 1. Install two new needle bearings (66) (item 22, WP 0175) and a new plain encased seal (67) (item 275, WP 0175) in solenoid control housing (44). WARNING Retaining rings are spring tension devices: take care when removing or installing them. They can slip or break and become airborne causing eye damage or other bodily harm. 2. Install solenoid control housing (44) on straight shaft (16) with two flat washers (60 and 65) and new retaining rings (59) (item 12, WP 0175) and (64) (item 8, WP 0175), using snap ring pliers (item 81, WP 0176). 3. Install solenoid stop control (57) on pin (58) in solenoid control housing (44). 4. Install a new plain encased seal (63) (item 189, WP 0175) in solenoid housing assembly (12). 5. Install a new retaining ring (62) (item 8, WP 0175) on straight shaft (16) then install solenoid housing assembly (12) on straight shaft (16) and over solenoid control housing (44). 6. Install new bearing (61) (item 322, WP 0175) in solenoid housing assembly (12) and secure to straight shaft (16) with a new retaining ring (62) (item 8, WP 0175). 7. Install new gasket (54) (item 188, WP 0175) and access cover (53) on solenoid housing assembly (12). 8. Secure access cover (53) to housing assembly (12) using three screws (50), with new lock washers (51) (item 92, WP 0175), and three flat washers (52). 65 64 16 59 60 67 58 57 66 44 66 51 63 12 50 62 61 62 54 52 53 WP 0123 00-11