TM-9-2815-200-35 Maintenance Manual for AVDS-1790-2M AVDS-1790-2A and AVDS-1790-2AM Engines Download
Page 6 of 779
CAUTION / WARNING— Continued  Warning: Use goggles, rubber gloves, and rubber apron when cleaning parts in  carbon removing compound. Provide adequate ventilation. Avoid inhalation of  fumes and skin contact. If compound is splashed on skin, flush with fresh water and  wash with alcohol, Alcohol containing 2 to 3 percent camphor is preferable.  (Paragraph 6-24a(1) )  Warning: The valves and locks are under heavy spring tension. Exercise extreme  care when removing locks, retainers, and springs. (Figure 6-48 )  Caution: Do not use an arbor press to remove ball bearings from drive cluster  gear. The gear is designed with a shoulder between the two bearings. (Figure 6-83)  Caution: The piston oil cooling valve is a spring loaded assembly. Exercise care  when disassembling. (Figure 6-86 )  Warning: The oil pressure regulator cover is spring loaded. Exercise care when  removing cover. (Figure 6-103)  Caution: Do not attempt to remove the diaphragm drive coupler half from the  shaft using a standard puller as shown in figure 6-163. This may distort the coupler  and render it unserviceable. Use puller as shown. (Figure 6-165)  Caution: Use extreme care in this operation to prevent damage to vane cover on  gearshaft. (Paragraph 6-42a(6) (c))  Warning: Cleaning solvents and solvent cleaning compounds are toxic and  flammable and must be used only in a well ventilated room. Take adequate safe  guards for fire prevention in work area. Use protective clothing and avoid contact of  these solutions with the skin. (Paragraph 6-47c(3 ) )  Caution: If lubricant is extended to face of washer nut, reliable retaining torque  cannot be obtained. (Figure 7-13)  Caution: The fuel injector pump advance assembly must always be installed and  secured before operating test stand. (Paragraph 6-42, d., (4), (g) )  Caution: Do not operate the starter motor continuously for more than one minute.  Allow a two-minute cool-off period before re-energizing the starter. (Paragraph 8-4c)