TM-9-2815-200-35 Maintenance Manual for AVDS-1790-2M AVDS-1790-2A and AVDS-1790-2AM Engines Download
Page 577 of 779
APPENDIX B DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LIST Section I INTRODUCTION 1. Scope This appendix lists repair parts and special tools required for the performance of direct support, general support and depot maintenance of Engine, with Container: Turbosupercharged, Diesel, Fuel Injection, 90-degree “V” Type, Air Cooled, 12 Cylinder Assembly, Continental Models AVDS-1790-2M (2815-856-4996), AVDS-1790-2A and AVDS-1790-2AM (2815- 856.9005). Part number and Federal stock number indexes are also included. 2. General This Repair Parts and Special Tools List is divided into the following sections: a. Repair Parts - Section II. A list of engine parts, in Government Group number sequence and keyed to figure and number, showing authorized repair parts for the performance of maintenance at the direct support, general support and depot levels. b. Special Tools and Test Equipment - Section III. A list of special tools and test equipment authorized for the performance of maintenance at the direct support, general support and depot levels is given in ascending Federal stock number sequence, cross-referenced to illustration figure number and item number. Quantities shown in the Special Tools List are those required for each support unit charged with the responsibility of supporting this equipment. c. General Use Standardized Parts - Section IV. A list of all standard hardware and parts in alphabetical part name order with the hardware listed in ascending sizes. d. Part Number and Federal Stock Number Indexes - Section V. A list of part numbers and Federal Stock numbers in ascending numerical sequence, cross-referenced to the illustration figure number and item number. 3. Explanation of columns The following provides an explanation of columns in the tabular lists in Sections II and III: a. Source, Maintenance, and Recoverability Codes (SMR), Column 1. (1) Source code, indicates the selection status and source for the listed item. Source codes Code “M” “P” “P2" “X1” “X2” used are: Explanation Repair parts which are not procured or stocked as separate supply items but are to be manufactured in indicated maintenance levels. The lowest maintenance level authorized to manufacture the item will be entered in the second digit position of the source code. Repair parts which are high mortality parts, stocked in or supplied from the GSA/DSA or Army supply system, and authorized for use as indicated maintenance categories Repair parts which are procured and stocked for insurance purposes because the combat or military essentiality of the end item dictates that a minimum quantity be available in the supply system. Applied to repair parts which are not procured or stocked, the requirement for which will be supplied by use of the next higher procured or stocked component or assembly. Applied to repair parts which are not stocked. The indicated maintenance category requiring such repair parts will attempt to obtain these parts by cannibalization; if not obtainable by can- nibalization, such repair parts will be requieitioned with supporting justification through normal supply channels. B-1