TM-9-2815-200-35 Maintenance Manual for AVDS-1790-2M AVDS-1790-2A and AVDS-1790-2AM Engines Download
Page 540 of 779
Figure 7-34. Overall view of engine showing progress of engine assembly at this point. d. Cooling Fan Vanes and Cooling Fans. Refer to figures 4-35, 4-34, and 4-88. 7-17. Engine Accessories Refer to Table 7-13 for illustrations and assembly instructions. References are listed in the table. Table 7-13. Installing Engine Accessories Component References Fuel Pump Para 7-17a, Figs. 4-3 through 4-1 Turbosupercharger and Lower Shroud Plates Para 7-17b, Figs. 4-33 through 4-18 Starter Para 7-17c, Figs. 4-8, 4-7, 5-1, 4-9, 4-4 Time Totalizing Meter Para 7-17d, Figs. 5-5, 5-4, 4-10 Generator Para 7-17e, Figs. 7-31, 4-17 through 4-13, 4-11 a. Fuel Pump. Refer to figures 4-3 through 4- 1. b. Turbosupercharger and Lower Shroud Plates. Refer to figures 4-33 through 4-18. c. Starter. Refer to figures 4-8, 4-7, 5-1, 4-9, and 4-4 and (1) through (3), below. (1) Install starter while engine is still mounted on overhaul stand (figs. 4-8 and 4-7). (2) Install multiple leg sling - 4910-919- 2884 (fig. 5-1) on suitable chain hoist. Install 7-28 hooks of sling in engine lifting eyes and take up the slack. Remove four bolts and flat washers securing engine to overhaul stand bracket. Lift engine and move overhaul stand. Lower engine on suitable blocks or moveable dolly maintaining lifting sling hook-up as a precaution against engine tipping during remaining assembly operations. (3) Install starter cradle and support on engine (fig. 4-9 and 4-4).