TM-9-2815-200-35 Maintenance Manual for AVDS-1790-2M AVDS-1790-2A and AVDS-1790-2AM Engines Download
Page 495 of 779
Section XIV. OVERHAUL OF GENERATOR AND STARTER SUPPORTS, FUEL CHECK VALVE, PRIMARY AND SECONDARY FUEL FILTERS, AND FUEL / WATER SEPARATOR 6-54. General assembly accompany the overhaul operations. This section covers the overhaul of the Stud identification information is included in the generator and starter supports, fuel check valve, overhaul procedures where applicable. Refer to primary and secondary fuel filters, and the following table (table 6-42) for applicable fuel / water separator. Specific instructions on illustrations and instructions for overhaul disassembly, cleaning, inspection, repair, and operations. Table 6-42. Generator and Starter Supports, Fuel Check Valve, Primary Generator and Starter Sup- ports Fuel Check Valve and Secondary Fuel Filters, and Fuel / Water Separator Disassembly Primary and Secondary Fuel Filters Fuel / Water Separator and Fuel Drain Tubes 6-55. Overhaul of Generator and Starter Supports a. Disassembly. Disassemble generator support following instructions which accompany figure 6-240. The starter support was disassembled during starter removal, Chapter 4. Para 6-55a Fig. 6-240 Para 6-56a Figs. 6-241, 6-242 Para 6-57a Figs. 6-244, 6-245 Para 6-58a Figs. 6-246, 6-247 Cleaning Para 6-2 Para 6-2 Para 6-57b Para 6-58b Figure 6-240. Disassembling generator cradle, support, and “U” bolt. Inspection Para 6-3 Para 6-3 Para 6-57b Para 6-58b Repair Para 6-4 Table 6-43 Para 6-4 Para 6-57b Para 6-58b Assembly Para 6-55d Fig. 6-240 Para 6-56c and Figs. 6-242, 6-241,6-243 Para 6-57c Figs. 6-245, 6-244 Para 6-58c Figs. 6-247, 6-246 1. Remove self-locking nut (A). 2. Remove clamping bar (B) and “U” bolt. 3. Remove two self-locking nuts (C) and flat washers attaching cradle to support. 6-201