TM-9-2815-200-35 Maintenance Manual for AVDS-1790-2M AVDS-1790-2A and AVDS-1790-2AM Engines Download
Page 477 of 779
Disassemble 1. Remove two retaining rings (A) from cross shaft bracket. 2. Remove ball bearing (B) from brakcet. 3. Remove two ball bearings (C) from cross shaft lever. 4. Remove two retaining rings (D) from lever. 5. Loosen two nuts (E) and remove left and right rod end bearings (F) from adjustable control rod. Note. The rod bearings (F) are pinned and are not to be disassembled. Do not attempt to disassemble connecting link. Assemble 1. Install left and right rod end bearings (F) in ad- justable control rod and tighten nuts (E). 2. Install two retaining rings (D) in cross shaft lever. 3. Position two ball bearings (C) in lever. 4. Position ball bearing (B) in cross shaft bracket. 5. Install two retaining rings (A) in bracket. Figure 6-220. Disassembling or assembling cross shaft lever, bracket, and adjustable control rod. b. Cleaning. Refer to paragraph 6-2. c. Inspection and Repair. Refer to paragraphs 6-3 and 6-4 for procedures and table 6-36 for overhaul standards. 6-183