TM-9-2815-200-35 Maintenance Manual for AVDS-1790-2M AVDS-1790-2A and AVDS-1790-2AM Engines Download
Page 475 of 779
6-45. Overhaul of Throttle Control Cross Shaft and Fuel Injection Pump Linkage a. Disassembly. Disassemble throttle control cross shaft and fuel injection pump linkage following instructions which accompany figures 6-215 through 6-220. Remove 1. Place the throttle control cross shaft and fuel injection pump linkage (A) in a soft-jawed vise. 2. Remove retaining ring (B). 3. Remove ball bearing (C) as shown in figure 6-216. Install 1. Place the throttle control crow shaft and fuel injection pump linkage (A) in a soft-jawed vise. 2. Install ball bearing (C) on cross shaft. 3. Install retaining ring (B). Figure 6-215. Removing or installing camshaft end plate ball bearing retaining ring and ball bearing. Remove 1. Remove camshaft end plate bearing inner retaining ring (A). 2. Remove cap screw (B) and lock washer (or assembled washer bolt). 3. Remove control lever (C) from cross shaft. 4. Remove cross shaft bracket bearing retaining ring and bracket (D) with bearing as shown in figures 6-215 and 6-216. 5. Remove cross shaft lever bearing retaining ring and lever (E) with two bearings as shown in figures 6-215 and 6-216. Install 1. Install cross shaft lever (E) with bearings, and retaining ring as shown in figure 6-215. 2. Install cross shaft bracket (D), with bearing, and retaining ring as shown in figure 6-215. 3. Install control lever (C) on cross shaft. 4. Install cap screw (B) and lock washer. 5. Install camshaft end plate bearing inner retaining ring (A). Figure 6-217. Removing or installing cross shaft levers and bracket. Figure 6-216. Removing camshaft end plate ball bearing. 6-181