TM-9-2815-200-35 Maintenance Manual for AVDS-1790-2M AVDS-1790-2A and AVDS-1790-2AM Engines Download
Page 468 of 779
Table 6-33. Camshaft and Throttle Control Cross Shaft and Fuel Injection Pump Linkage Component Camshaft and Associated Parts Throttle Con- trol Cross Shaft and Fuel Injection Pump Linkage Disassembly Para 6-44a Figs. 6-207 through 6-213 Para 6-45a Figs. 6-215 through 6-220 6-44. Overhaul of Camshaft Cleaning Para 6-2 Para 6-2 Inspection Para 6-44c Table 6-34 Para 6-3 Table 6-36 Repair Para 6-44c Table 6-35 Fig. 6-214 Para 6-4 Assembly Para 6-44d Figs. 6-213 through 6-207 Para 6-45d Figs. 6-220 through 6-215 following instructions which accompany figures a. Disassembly. Disassemble camshaft 6-207 through 6-213. Remove Install 1. Remove lifting eye (A), preformed hose, and in- 1. Position rubber hose on camshaft drive abaft flange tercylinder hose flange, and separate the liiting eye and and install two hose clamps (D). flange from hose. 2. Position a new camshaft end cover plate gasket (C) on 2. Remove the remaing four groups of intercylinder hose camshaft. flanges (B) and preformed hoses and separate tbe 3. Position two intercylinder hose flanges (B) on each of flanges from hoses. four preformed hoses and position hose assemblies on 3. Remove and discard the camshaft end cover plate camshaft. gasket (C). 4. position lifting eye (A) and remaining intercylinder 4. Remove two hose clamps (D) and the rubber hose hose flange on remaining preformed hose and position from camshaft drive shaft flange. hoee assembly on camshaft. Figure 6-207. Removing or installing lifting eye, intercylinder hose flanges, and hoses. 6-174