TM-9-2815-200-35 Maintenance Manual for AVDS-1790-2M AVDS-1790-2A and AVDS-1790-2AM Engines Download
Page 467 of 779
Note. Before installing assembled fuel in- and accessory drive housing stamped numbers jection advance assembly and fan drive bevel correspond to their proper location before gearshaft, check gearshaft backlash and re-shim assembling. as necessary (fig. 6-189). Be sure bearing cap Figure 6-206. Installing fuel injection advance bearing cap. Section X. OVERHAUL OF CAMSHAFT AND THROTTLE CONTROL CROSS SHAFT AND FUEL INJECTION PUMP LINKAGE 6-43. General procedures where applicable. a. This section covers the overhaul of the following table (table 6-33) cam shafts and throttle control cross shaft and illustrations and instructions fuel injection pump linkage. Specific instructions operations. Refer to the for applicable for overhaul on disassembly, cleaning, inspection, repair, and b. Overhaul of the right and left camshafts is assembly accompany the overhaul operations. similar. For instructional purposes, procedures Overhaul standards of individual components for the right camshaft will be illustrated with follow the inspection procedures. Stud iden- references to the left camshaft only where tification information is included in the repair overhaul procedures vary. 6-173