TM-9-2815-200-35 Maintenance Manual for AVDS-1790-2M AVDS-1790-2A and AVDS-1790-2AM Engines Download
Page 382 of 779
f. Assembly. Refer to figures 6-87 through 6- 67. Torque tighten the drive shaft lock nut (fig. 6-72) and driven gear nut (fig. 6-70) as specified. Note. The drive shaft (B, fig. 6-84) must be pressed into the bearings from the large gear end of the cluster gear. 1. Position ball bearing (A) in bore of drive cluster gear. 2. Press bearing into gear until bearing is seated against the gear. Note. Turn gear over and install thrust washer (B, fig. 6-85). Aline thrust washer with installed bearing and press second bearing in gear, as outlined above, until seated against thrust washer. Figure 6-87. Pressing ball bearing into drive cluster gear. 6-88