TM-9-2815-200-35 Maintenance Manual for AVDS-1790-2M AVDS-1790-2A and AVDS-1790-2AM Engines Download
Page 278 of 779
Note. Position flywheel to locate eye bolt hole at top center. 1. Install three 9 / 16 x 1-3/4 in. bolts (A), used for attaching transmission drive gearshaft assembly, as puller screws into puller screw holes in flywheel 2. Alternately tighten bolts and pull flywheel (B) from crankshaft dowel pins only far enough to permit in- stallation of lifting eye bolt (C). 3. Install eye bolt - 5306-017-6143 and attach suitable chain hoist. Continue tightening puller bolts to remove flywheel from crankshaft dowel pins (fig. 5-162). Figure 5-161. Preparing flywheel for removal. Caution: Use care in removing the flywheel from the dowel pins so as not to bind the flywheel on the pins. 1. Remove flywheel (A) from the two dowel pins in flange on crankshaft. 2. Remove three puller bolts (B) from flywheel. Figure.5-162. Removing flywheel using eye bolt-5306-017-6143. 5-92