TM-9-2815-200-35 Maintenance Manual for AVDS-1790-2M AVDS-1790-2A and AVDS-1790-2AM Engines Download
Page 250 of 779
Disconnect 1. Remove cap screw (A) and flat washer attaching right camshaft gear housing to rocker arm cover. 2. Do not remove two cap screws (B) and flat washers attaching housing to cylinder until camshaft is removed (fig. 5-115). Connect 1. The two cap screws (B) and flat washers securing right camshaft gear housing to cylinder are installed when camshaft is installed (fig. 5-115). Remove 2. Install cap screw(A) and flat washer securing housing 1. Remove bolt (A) attaching transmission oil cooler end to rocker arm cover. shroud retaining tab to cylinder No. 6R rocker arm cover. Remove tab. Figure 5-107. Disconnecting or connecting 2. Remove three bolts (B) and flat washers. right camshaft gear housing at cylinder 3. Remove seven bolts (C) and flat washers. 6R rocker arm cover, 4. Remove two cap screws (D) and flat washers. Install 1. Install two cap screws (D) and flat washers. 2. Install seven bolts (C) and flat washers. 3. Install three bolts (B) and flat washers. 4. Position transmission oil cooler end shroud retaining tab on cylinder No. 6R rocker arm cover. Install bolt (A) securing tab and cover. Figure 5-108. Removing or installing rocker arm cover bolts and cap screws. 5-64