TM-9-2815-200-35 Maintenance Manual for AVDS-1790-2M AVDS-1790-2A and AVDS-1790-2AM Engines Download
Page 236 of 779
Disconnect 1. Remove cotter pin, slotted nut (A), and bolt attaching throttle adjustable rod. Remove adjustable rod. 2. Remove cotter pin, slotted nut (B), and bolt attaching throttle rod to intermediate throttle lever. 3. Remove cotter pin, slotted nut (C), flat washer, and bolt attaching throttle rod to injection pump lever. Remove red. Connect 1. Position throttle rod on injection pump lever. Install bolt, flat washer, slotted nut (C), and cotter pin securing rod. 2. Install bolt, slotted nut (B), and cotter pin securing throttle rod to intermediate throttle lever. 3. Position throttle adjustable rod on intermediate throttle lever. Install bolt, slotted nut (A), and cotter pin securing rod. Remove 1. Remove three self-locking nuts (A) attaching in- termediate throttle lever support to front fan drive housing. 2. Remove lever support (B), shaft, and throttle lever as a unit. Install 1. Position lever support (B), shaft, and throttle lever as a unit on front fan drive housing. 2. Install three self-locking nuts (A) securing lever support to drive housing. Figure 5-83. Removing or installing intermediate throttle lever support. Figure 5-82. Disconnecting or connecting throttle rods at intermediate throttle lever. 5-50