TM-9-2815-200-35 Maintenance Manual for AVDS-1790-2M AVDS-1790-2A and AVDS-1790-2AM Engines Download
Page 199 of 779
Figure 5-22. Removing or installing right turbosupercharger oil inlet hose and transmission shroud. Remove 1. Disconnect turbosupercbarger oil inlet hose (A) from bulkhead adapter elbow and remove hose. 2. Remove two machine screws (B) attaching right transmission shroud and remove shroud. Note. Left turbosupercharger oil inlet hose and transmission shroud are removed or in- stalled in the same manner. Install 1. Position right transmission shroud on rear of engine and install two machine screws (B) securing shroud. 2. Connect oil inlet hose (A) to bulkhead adapter elbow. 5-6. Manifold Heater Tubes, Solenoids, and Filter, Cylinder Head Oil Drain Lines, and Intake Manifold Assemblies Refer to Table 5-3 for illustrations and disassembly instructions. Figure references are listed in the table. Table 5-3. Manifold Heater Tubes, Solenoids and Filter, Cylinder Head Oil Drain Lines, and Intake Manifold Assembly- Component Figure Reference Manifold Heater Tubes, Hoses, Fuel Check Valve, Fuel 5-23 through 5-27 Filter, Bracket. and Solenoid Valves Cylinder Head Oil Drain Tubes 5-28 through 5-32 Intake Manifold, Manifold Heater, and Turbosupercharger 5-33 Air Outlet Elbow Remove 1. Remove machine screw (A) attaching right manifold beater fuel return tube clamp to right rear shroud. 2. Disconnect fuel return tube (B) from heater and tube tee. Remove tube. Note. Left manifold heater fuel return tube is removed or installed in the same manner. Install 1. Position right manifold heater fuel return tube (B) on right rear shroud and connect to heater and tube tee. 2. Install machine screw (A) securing fuel return tube clamp to right rear shroud. Figure 5-23. Removing or installing right manifold heater fuel return tube. 5-13