TM-9-2815-200-35 Maintenance Manual for AVDS-1790-2M AVDS-1790-2A and AVDS-1790-2AM Engines Download
Page 197 of 779
Figure 5-19. Removing or installing right oil cooler end shroud. Remove 1. Remove self-locking nut (A), washer, and cap screw attaching brace to support beam. 2. Remove self-locking nut (B), two spacers, bolt, and grommet attaching brace to turbosupercharger tie rod. 3. Remove six self-locking nuts (C) and three flat washers attaching support beam to cylinders and rem ove beam. Install Note. The flat washers are located at cylinder Nos. 3, 4 and 5 on both cylinder banks. 1. Position support beam on engine and install six self- locking nuts (C) and three flat washers securing beam to cylinders. 2. Install self-locking nut (B), two spacers, bolt, and grommet securing brace to turbosupercharger tie rod. 3. Install self-locking nut (A), washer, and cap screw securing brace to support beam. Figure 5-20. Removing or installing cooler support beam. right oil 5-11