TM-9-2815-200-35 Maintenance Manual for AVDS-1790-2M AVDS-1790-2A and AVDS-1790-2AM Engines Download
Page 189 of 779
5-3. Remove Engine Accessories The starter, cradle, and support, generator cradle support and air intake tube must be removed to allow the engine to be mounted on the overhaul stand. Remove the fuel pump, starter, generator, turbo supercharger, and associated components as outlined in Chapter 4 and remove the time totalizing meter. Ap- propriate figure references are listed in table 5-1. Remove 1. Disconnect time totalizing meter electric lead (A). 2. Remove four self-locking nuts (B) and electrical lead ground wire. 3. Remove time totalizing meter (C) from crankshaft damper and oil filter housing. Install 1. Position time totalizing meter (C) on crankshaft damper and oil filter housing. 2. Install four self-locking nuts (B) and electrical lead ground wire. 3. Connect time totalizing meter electrical lead (A). Figure 5-5. Removing or installing time totalizing meter. Note. Two clamps are used to secure the time totalizing meter electrical lead on the basic engine. The clamps are installed to secure the electrical lead to prevent damage. Figure 5-4. Disconnecting or connecting time totalizing meter electrical lead clamps. Section ll. Installation OF ENGINE ON OVER HAUL STAND AND DISASSEMBLY INTO SUBASSEMBLIES 5-4. General 5-5. Shrouding, Cooling Fans, Oil Coolers, This section covers the installation of t h e Beams, and Associated Parts engine on the overhaul stand and disassembly of Refer to Table 5-2 for illustrations and the engine into subassemblies. Components are disassembly instructions. Figure references are grouped together in proper disassembly order. listed in the table. 5-3