Sign up to sell your inventory with NSN Lookup

TM-9-2815-200-35 Maintenance Manual for AVDS-1790-2M AVDS-1790-2A and AVDS-1790-2AM Engines Download

Page 175 of 779

Note. Draw flywheel to crankshaft by in- stalling three transmission drive shaftgear and flywheel bolts and alternately tighten about one turn at a time to draw flywheel into dowel pins without binding. Remove bolts and install transmission drive gearshaft following the above procedure until both flywheel and transmission drive gearshaft are properly alined on dowel pins. Figure 4-183. Installing flywheel, using bolts to draw flywheel against crankshaft. Section X. SERVICE OPERATIONS 4-21. General of engine disassembly to perform. Refer to Table This section covers service operations 4-9 for illustrations and instructions on service allocated to the Direct Support Maintenance operations covered in this section. Figure and Organization. Procedures outlined in this section paragraph references will be listed under ap- are for service operations requiring a minimum propriate headings in the table. 4-93