NMWR-9-2815-220 Overhaul Manual for M60 M88 Engine AVDS-1790-2CA, AVDS-1790-2DA, AVDS-1790-2DR Download
Page 96 of 1014
NMWR 9-2815-220 CRANKCASE ASSEMBLY OVERHAUL—Continued 0006 00 ASSEMBLY 1. Refer to WP 0005 00 for general assembly procedures. 2. Assemble crankcase assembly in accordance with TM 9-2815-220-34. 3. Application of historical data plate to crankcase assembly. (a) After inspection of crankcase is complete, based on quality assurance acceptance, the historical data plate shall be stamped/marked in accordance with TB ORD 1030. NOTE Entries must be made on data plate before affixing to crankcase. If plate is already mounted, remove and make necessary entries, then remount. (b) Four holes shall be drilled into the crankcase in accordance with drawing specification 12354391. (c) Affix historical data plate on the right side of the crankcase below the No. 3R cylinder and secure with four drive screws (1) and washers (2). 4. Historical data plate entries. Prescribed entries will be stamped on plate prior to installation. These entries are defined below. (a) Date manufactured. Stamp date of manufacture of engine (b) Serial number. Stamp the engine serial number in space provided. (c) Model. Stamp the model number of the engine in space provided. (d) Facility. Stamp the initials of the facility or unit who performed the repair/overhaul IAW TB ORD 1030. Figure 11. Historical Data Plate. 0006 00-14 Change 1