NMWR-9-2815-220 Overhaul Manual for M60 M88 Engine AVDS-1790-2CA, AVDS-1790-2DA, AVDS-1790-2DR Download
Page 831 of 1014
NMWR 9-2815-220 FINAL INSPECTION RECORD (FIR) 0047 01 0047 01-1 Change 1 Final Inspection Records. Final inspection will be accomplished to determine conformance to the requirements of this NMWR. The inspector will use the Final Inspection Record as a guide in conducting inspection of the engine or engine components, individually or collectively. Inspections and tests need not be conducted in the order listed; however, all inspection characteristics must be completed prior to submitting to the QA representative for acceptance. Three sets of final inspection records follow in this work package, one for each model engine covered in this NMWR. Final Inspection Deficiencies. Deficiencies disclosed during final inspection will be delineated on the deficiency sheets, following each final inspection record set, which will be attached to the Final Inspection Record and become a permanent part of the inspection record. Defective engines will be returned for repair of defects or replacement of defective parts noted on the deficiency sheet. Corrective action taken will be noted in the proper column and the components resubmitted for acceptance inspection of the listed deficiencies. The inspector will reinspect the listed deficiencies for correction, and initial each entry of the deficiency sheet if found to be in compliance. Table 1. Final Inspection Record (FIR) Engine, Diesel: 12-Cylinder, 90-Degree “V”-Type, AVDS-1790-2CA Dynamometer Tests and Final Inspection Serial No. Contract No. Dynamometer Test. Final Inspection Contractor Inspector and Date Contractor Inspector and Date Government Inspector and Date Government Inspector and Date Special Instructions: (1) Contractor inspection and data shall be completed prior to submission to government inspector for acceptance. (2) Tests shall be performed in accordance with the requirements of MIL-E-62177(C). (3) Inspections shall be performed to determine conformance with engine installation 12314611 and reference drawings specified. (4) Dynamometer test results shall be recorded on final run.