NMWR-9-2815-220 Overhaul Manual for M60 M88 Engine AVDS-1790-2CA, AVDS-1790-2DA, AVDS-1790-2DR Download

Page 804 of 1014

NMWR 9-2815-220 ENGINE SHIPPING AND STORAGE OVERHAUL—Continued 0044 00 INSPECTION 1. Inspect components not covered by an OIP in accordance with WP 0005 00. 2. Refer to WP 0005 00 and the OIPs in Table 1 for specific inspection criteria for selected items. 3. Discard all mandatory replacement parts. Refer to Figure 1. 4. Inspect the exterior and interior of the upper and lower sections of the container for dents, cracks, or a defective weld. Check mounting flanges for bends. Bends that do not affect proper alignment of the upper and lower sections of the container are permissible. Inspect the lower section of the container for cracked mounting flanges, bent, or stripped studs. Inspect vibration damper mounts for cracks, tears, or separation of bonding between metal and rubber. Inspect container skids for splits or cracks. Minor cracks and dents are acceptable if serviceability is not affected. Table 1. Components Requiring Overhaul Inspection. COMPONENT OIP Upper section container assembly (item 1, Figure 1) 10912298 (Table 2) Engine mount bracket (item 5, Figure 1) 10951230 (Table 3) Lower section container assembly (item 6, Figure 1) 10912271 (Table 4) Engine mount bracket (item 18, Figure 1) 10951231 (Table 5) REPAIR 1. Refer to WP 0005 00 for general repair instructions. 2. Refer to WP 0005 00 when repairing cracks by welding. Remove weld splatter. 3. Straighten all dents which would interfere with required clearance, i.e., approximately three to four inches of clearance between component and inside surface of container. Straighten bends that might affect proper alignment. 0044 00-2 Change 1