NMWR-9-2815-220 Overhaul Manual for M60 M88 Engine AVDS-1790-2CA, AVDS-1790-2DA, AVDS-1790-2DR Download
Page 616 of 1014
NMWR 9-2815-220 OIL FILLER AND INDICATOR TUBES OVERHAUL—Continued 0030 00 INSPECTION 1. Inspect components not covered by an OIP in accordance with WP 0005 00. 2. Refer to WP 0005 00 and the OIPs in Table 1 for specific inspection criteria for selected items. 3. Discard all mandatory replacement parts. Refer to Figure 1. Table 1. Components Requiring Overhaul Inspection. COMPONENT OIP Oil filler and oil gage rod tube cap (items 1 and 9, 8717157 (Table 2) Figure 1) Oil gage rod tube neck (item 5, Figure 1) 10935619 (Table 3) Oil filler upper tube assembly (item 13, Figure 1) 12314592* and 11682647** (Table 4) Oil filler tube support upper mounting bracket 11682609** (Table 5) (item 18, Figure 1) Oil filler tube support lower angle bracket 11682610** (Table 6) (item 24, Figure 1) Oil filler lower metal tube assembly (item 26, Figure 1) 11641927 (Table 7) Oil liquid level gage rod (item 31, Figure 1) 11684006* and 12275750** (Table 8) Oil gage rod tube filler neck (item 32, Figure 1) 11684018* and 11684226** (Table 9) Oil filler tube support double angle bracket 12314591** (Table 10) (item 39, Figure 1) *Models AVDS-1790-2CA and AVDS-1790-2DA **Model AVDS-1790-2DR REPAIR 1. Refer to WP 0005 00 for general repair instructions. ASSEMBLY 1. Refer to WP 0005 00 for general assembly procedures. 2. Assemble oil filler and indicator tubes in accordance with TM 9-2815-220-34. TESTING 1. Test. A pressure test of the upper filler tube assembly and the gage rod neck assembly, with the cap assemblies installed and closed, is necessary to assure fording capability. Install the cap and neck assemblies to test equipment and pressurize to 6 in. (152.400 mm) of water. The cap must not indicate any air leakage. 0030 00-2