NMWR-9-2815-220 Overhaul Manual for M60 M88 Engine AVDS-1790-2CA, AVDS-1790-2DA, AVDS-1790-2DR Download
Page 147 of 1014
NMWR 9-2815-220 GENERATOR DRIVE ASSEMBLY OVERHAUL—Continued 0009 00 INSPECTION – Continued (c) Insert splined shaft (Figure 2) into gear assembly and clamp using vee band clamp (Figure 1) from the generator assembly. (d) Using torque wrench as shown in Figure 3, check the clip torque for no excursion in either direction at 167 lb-ft (226.45 N•m) at ambient 75°F (24°C) temperature. (e) Note deflection in degrees from zero to 167 lb-ft (226.45 N•m) torque. If rotation is less than 8 degrees or greater than 17 degrees, the drive gear is defective and must be replaced. Figure 2. Splined Shaft. Figure 3. Special Fixture Assembly-Generator Gear Slip Clutch Torque Checking. 0009 00-3