MIL-DTL-62177E AVDS-1790-2 Engine Series Specification Download
Page 21 of 26
MIL-DTL-62177E 21 4. Lubricating oil pressure, (main oil gallery), psi. 5. Crankcase pressure, in. of water. 6. Lubricating oil temperature, °F. 7. Blow-by, ft 3 /min. 8. Fuel flow, lb per hour. 9. Fuel pressure after secondary fuel filter, psi. 10. Fuel temperature at secondary fuel filter, °F. 11. Air temperature at air cleaner inlet, °F. 12. Test cell ambient air temperature, °F. 13. Specific oil consumption, lb per gross hp-hour, at 50-hour intervals. 14. Generator/Alternator, volts and amperes. 15. Lubricating oil quantity (quarts) added at idle periods. In addition to the above, the following shall also be monitored: 16. Barometric pressure of test cell-once one 4-hour period. 17. Exhaust smoke density-once each 50-hour period, ± 5 hours. f. Smoke. The smoke at the rated power and speed shall be monitored and shall not exceed a 3.5 Bosch rating throughout the test (see 6.3). g. Disassembly. At the completion of the post-test performance test specified in 4.5.4.12.2.1.a, the engine shall be disassembled completely (as required) for visual inspection for evidence of wear or stress, and the recorded results published for corrective action as required. Depot Maintenance Work Requirement (DMWR) accept and reject procedures are the basis of inspection criteria. 4.6.4.1.2.2 Test cycle. The test cycle shall be 400 hours divided into 4 periods of 100 hours each. Each 100-hour period shall consist of twenty 5-hour cycles. Each 5-hour cycle shall be as follows: Period Engine speed Power Endurance hours 1 2 3 4 5 Idle 2000 2400 1800 2400 0 100 0 85 50 0.5 1.0 0.5 1.0 0.5 6 2400 100 1.0 7 1200 25 0.5 Total endurance 5.0 NOTE: In percentage of full power setting gross hp at respective speed